A friend asked about our
minivan bike rack so I thought the easiest way to describe it was on my cycling
blog. The basic “model” would be for two
bicycles with a couple of options, depicted at the end of this post. It could also
be easily adapted for a pick-up truck. Thanks to my friend David for suggesting
improvements to my original design.
Step One. Buy a plank of wood 11 inches x ¾ inches x
approx. 4 ft. The length should be about ¼ inch less than the width of the
minivan at the point where the rack will sit. Do not use a width of less than
11 inches; otherwise the rack will slide around in the van. If you are rather
obsessive, you can put a couple of coats of polyurethane on the plank.
Step Two.
Buy at least two bike mounts. The ones I use are the XPORT universal bike
mount, normally about $25 tho’ usually on sale at Performance for $19 and
occasionally for even less. Another
options might be the Hollywood T970 Fork Mount or the Delta Bike Pro 2 Fork
Mount. Also buy four, one-inch inch
stainless steel bolts with nuts and washers.
Step Three. Position the two bike mounts in the centre of
the plank and about 9 inches from the ends. Drill appropriate bolt holes and
countersink the holes on the underneath of the plank which can then sit flat on
the van floor. The countersink uses the type of bit shown below and needs to be
enough to house the nuts. The washers are placed between the bolt head and the
mount. Make sure everything is ultra-tight.
Step Four.
Put adhesive-backed felt protector strips on the ends of the plank to prevent
scuffing of the inside of the van.
Step Five.
Mount the bikes (with front wheels removed) on the rack as shown with the bars
facing the rear. The front wheels can be suspended from the hooks in the van
with a mini-bungee or similar. It’s possible that you will also need a couple
of bungees from the pedals to the minivan roof hooks to provide maximum stability.
Option One.
As you can see in the photos, I actually have a third bike mount in the center
of the plank because if I am on a long trip with only one bike, mounting it in
the middle makes for much easier packing of all the other luggage.
Option Two.
If you want to carry three bikes and three riders, you will most likely need to
remove one of the center-row seats. Make another shorter (perhaps 3 ft.)
version of the rack which then sits behind the front seats. Then mount the two
outside bikes as normal with the third bike between them and reversed (back
wheel at the rear of the van).
